Elentek Wastek PRO 1 Mono - 1 Pump Control Panel

Wastek Pro is designed to fit into small spaces. The peculiarity of this control panel is the possibility to use an air pressure sensor, particularly useful when the installation site is a small well. Wastek Pro allows an accurate level detection from 0 to 100 cm and is expandable with a range of connectivity modules.

FUNCTIONS

• LCD display for displaying and programming: voltage, current, power factor, hours of operation, number of starts, motor status, alarms, sensor signal and thresholds
• AUTOMATIC - 0 (standby) – MANUAL pushbuttons (fixed or pulse)
• Language settings (Italian, English, French, Spanish, German)
• Dry running protection by: level probes/floats/pressure switches and minimum current
• Up to 4 control inputs: floats/pressure switches
• Input for air sensor and 4-20 mA or 0-10V analogue signal
• Unit of measurement of analog signal: centimetres or metres
• Clicson inputs with automatic reset (can be disabled)
• Inputs inversion (from normally open to normally closed)
• Automatic reset from minimum current alarm settable with 4
programmable times
• Start-up and shutdown delay time (programmable)
• Maintenance time control (programmable
• Pushbutton for manual operation (fixed or pulse)
• Provision for run capacitors on single-phase model (not included)

ADDITIONAL FUNCTIONS WASTEK PRO 2

• Duty/standby (can be disabled)
• Immediate motor changeover in case of a fault

CONTROLS

• Electronic control of minimum and maximum voltage
• Electronic control of maximum motor current
• Electronic minimum motor current control
• Failure or incorrect phase sequence control on power supply input (can be disabled)

ALARMS

• Alarms reported: voltage status, levels, motor overload, minimum current, clicson motor
• System maintenance warning
• Alarm output contacts

PROTECTIONS

• Auxiliary and motor protection fuses
• Isolator (except for NB code)
• Box in ABS, IP55