Dewaterco HydroForce 10T/4 Submersible dewatering pump

HydroForce three-phase submersible pump, the most powerful in the Dewaterco range: designed for dewatering construction sites, building work, mines and emergencies, it delivers high flow rates and heads above 40 metres with clean or slightly dirty water. High-chrome steel impeller with rear design that helps expel solids, Eagle Burgmann double mechanical seal in silicon carbide, built-in thermal sensors, IP68 protection and 20 m of neoprene cable.

FEATURES

• High-chrome steel impeller with easier solids expulsion
• High resistance to abrasive liquids
• Stainless steel outer casing and strainer
• Eagle Burgmann double mechanical seal CA/CE + SiC/SiC
• Heat-treated AISI 410/420 stainless steel shaft
• Cooling jacket for continuous duty
• Built-in thermal sensors and 20 m of neoprene cable

APPLICATIONS

• Construction site drainage
• Mines and tunnels
• Public works and civil engineering
• Floods
• Cement industry
• Water intake from rivers

CONSTRUCTION AND MATERIALS

• Dry motor, 2 poles (2850 rpm), insulation class F, IP68
• AlSi7Mg motor cover and housing
• AISI 410 stainless steel shaft and rotor
• EN-GJL-200 cast iron pump casing
• H07RN-F cable, 20 m
• Liquid temperature 0-40 °C

TECHNICAL DATA - HYDROFORCE 10T/4

• Power: 10 Hp - 7,5 kW
• Power supply: three-phase 400V - 50Hz
• Full load current: 16 A
• Discharge: 4"
• Max flow rate: 1900 l/min
• Max head: 39 m
• Rated duty point: 980 l/min - 25 m
• Solids passage: 10 mm
• Pump weight: 69 kg
• Dimensions (A x B x C): 630 x 377 x 159 mm

Not sure this is the right pump for your system?

Answer a few questions, no technical data needed: one of our technicians will email you the right pump and its control panel, free and with no obligation. Try the configurator ›